This product contains nicotine. Nicotine is an addicative chemical.

How to Refill Lost Mary MT35000 Turbo: Step-by-Step Guide

Disposable vapes always leave us in a frustrating situation: the e-liquid runs dry quickly, and the rechargeable battery still can work. Do you want to refill it? I will do that. Like refilling the Lost Mary MT35000 Turbo. In this guide, we will show you exactly how to tackle this project.

Preparing to Refill Your Device

Before starting, prepare the following tools and supplies:

  1.  a small flathead screwdriver or a strong plastic prying tool
  2. An e-liquid (The Lost Mary MT35000 Turbo uses a specific mesh coil designed for nicotine salt e-liquids. You should look for a juice with a 50/50 VG/PG (Vegetable Glycerin/Propylene Glycol) ratio.)
  3. Paper towels or washcloths
  4. A safe, well-lit workspace

Safely Disassembling the Device

1. Popping the Top Section

Locate the small seams near the top of the mouthpiece of the vape. You can insert your small flathead screwdriver directly into this seam. Then, gently wiggle the tool back and forth to loosen the connection.

You need to apply light, upward pressure until the top mouthpiece section pops loose from the main body. If the top feels completely stuck, do not force it. Move the screwdriver to the side clips and apply gentle pressure there. Once the clips release, you can grab the mouthpiece with your fingers and carefully peel it back.

With the top shell removed, look inside the casing. You will clearly see the internal liquid tank and a small rubber gasket sitting near the top edge.

Refilling the E-Liquid

The MT35000 Turbo does not utilize an empty plastic reservoir; it utilizes a dense, sponge-like material to hold the e-liquid. You can refill the e-liquid into it. I don’t suggest putting out the internal tank; just refill it.

Saturating the Internal Sponge

Take the e-liquid and carefully position the dropper tip over the sponge. Slowly squeeze the bottle to drip a few drops onto the sponge, wait a second to soak in. Then repeat the step to distribute the liquid evenly across the entire surface.

Note: this step needs to be slow for the sponge to absorb the thick liquid. Or the liquid to pool on top and spill over the edges.

Avoid Overfilling the Chamber

Stop adding juice when the sponge looks fully saturated and glossy but does not have standing pools of liquid on top. Because if you squeeze too much liquid, the sponge will flood. A flooded sponge leads to terrible spit-back. That means you will get hot liquid in your mouth when you try to vape.

Step 3: Reassembling the Device

Putting the vape back together stands as the most critical part of the entire process. You must align everything perfectly.

Placing the Rubber Gasket

Grab the rubber gasket under the mouthpiece you set aside earlier. Look closely at the outer edge of the gasket. You will see a small alignment notch molded into the rubber. Find the corresponding notch on the plastic housing.

Closing the Outer Shell

Finally, take the top mouthpiece section and place it back over the internal components. Line up the sliding clips on the sides of the housing. Press down firmly on the top of the mouthpiece.
You will hear a distinct, satisfying click as the side clips lock back into their original positions. Wipe down the outside of the device with a paper towel to remove any stray drops of e-liquid.

Tips for Avoiding Leaks and Damage

Refilling a closed-system disposable vape carries a few inherent risks. Here are some best practices to keep your device working perfectly and avoid messy leaks in your pocket.

First, take a small test puff without fully inhaling. If the digital screen turns on, that means the internal coil fires correctly. If nothing happens, you likely misaligned the tank during reassembly. You need to pop the top off and push the tank down more firmly.

Second, always keep the device stored upright after a refill. If lying flat on its side or upside down, the refilled e-liquid will be easy to leak out.

Finally, don’t refill it too many times. It is better to refill a disposable vape one or two times. Like any pod cartridge, if your vapor tastes harsh, burnt, or metallic after a refill, the cotton surrounding the coil has degraded. At that point, you must responsibly recycle the device and purchase a new one.

Maximize Your Vaping Experience

Refilling your Lost Mary MT35000 Turbo offers a fantastic way to stretch your vaping budget. Disassembly is the first hard part. If you can finish this step, the refill and reassembly steps are easier. However, always prioritize safety, proceed slowly, and understand that this is a DIY solution outside manufacturer guidelines.

Have you successfully refilled your MT35000 Turbo? Did you try mixing a new flavor, or did you stick with the original profile? Share your experiences, drop your best tips, or ask any questions in the comments below!

Welcome to Noi Vape, my name is Noi Smith, a 5-year vaper! I hope I can share something about the latest vape trends, vape reviews, and tips in the exciting world of vaping with you!